Troubleshooting
Information on the Code Alarm CA5154 Remote Start Security System; Information on the Code Alarm CA5055 Remote Start and Keyless Entry Security System; Information on the Code Alarm CA5054 Remote Start and Keyless Entry Security System; See more Information, User Manual and Code List for the RCA RCR3273R Universal Remote Control. Aug 16, 2017 RCA RCR3273R Universal Remote Control RCR3273R Owner's Manual RCR3273R Code List Programming Operating Troubleshooting. Submit a request. Information, User Manual and Code List for the RCA RCR3273R Universal Remote Control CS Updated August 16, 2017 16:26. RCA RCR3273R Universal Remote Control. TV and television manuals and free pdf instructions. Find the user manual you need for your TV and more at ManualsOnline. RCA Universal Remote RCR3273R User Guide ManualsOnline.com. TV and television manuals and free pdf instructions. Find the user manual you need for your TV and more at ManualsOnline. Aug 16, 2017 Troubleshooting the RCA RCR3273R Universal Remote Control Why won't the RCR3273R operate my component? Make sure the remote is in the correct mode by pressing the corresponding device key (TV, SAT.CBL.DTC, DVD.VCR).
Problem: The remote does not operate your component.
• You must put the remote in the correct mode by pressing the
corresponding component key (TV, SAT·CBL, DVD•VCR) so the
• Remove any obstacles between the remote and the component.
Make sure to aim the remote at the IR sensor on the component.
• Make sure the batteries are fresh and are properly installed.
(See Battery Installation on page 1.) Replace the batteries with
two new AAA batteries, if necessary. Reprogramming may be
• Reset the remote. Remove the batteries, then press and hold
the number 1 key on the remote for several seconds to reset the
microprocessor inside the remote. Release the number 1 key,
reinstall the batteries, and press the POWER key. If the LED
lights up, reprogram the remote and try again. If the LED doesn’t
Problem: The remote can’t be programmed to operate
• If you are testing the remote after you have entered the code, you
may be too far away from the component or at a wrong angle.
This remote uses IR (infrared) technology to communicate with
components. The remote sends the code, and the component’s
IR sensor reads the code. Therefore, there must be an
unobstructed path between the remote and the IR sensor on the
component. Move closer and make sure you point the remote at
the component (DVD player, VCR, or DVR when programming
the DVD•VCR key; TV when programming the TV key; satellite
• If you’ve used the Direct Entry programming methods to enter
the codes for your brand and the unit is still not functioning
properly, try one of the Code Search methods. (See pages 3–5.)
• To control combo units, like TV/VCRs or TV/DVDs, you must
program the individual corresponding component keys to control
each part of the combo unit. Once programmed successfully,
the TV key controls the TV functions, and the DVD•VCR
key controls the VCR or DVD functions. There is a specific
section in the Code Lists for combo units. The codes in this
section should be tried first using Direct Code Entry on the TV
and DVD•VCR keys. If this is unsuccessful, follow the normal
programming methods for both the TV and the DVD•VCR keys.
• Make sure the batteries are fresh and are properly installed.
Problem: The remote doesn’t perform commands properly.
• You must put the remote in the correct mode by pressing the
corresponding component key (TV, SAT·CBL, DVD•VCR) so the
• Make sure component is “ready” (e.g., DVD player has disc
• You may have pressed an invalid key for the mode the remote is
• If you’re trying to turn on an RCA, GE, or PROSCAN
DVD•VCR) instead of the POWER key.
• If you’re trying to enter a channel number directly, try pressing
the ENTER key after entering the channel number as this is a
• There is a possibility that a programmed code may only be able
to control some of your component features (e.g., only turns a
component on and off). To confirm that the component key is
programmed with the correct code for maximum functionality,
test the component. Attempt to control a variety of the
component’s functions with the remote. If some of the features
of your components do not work, try programming the remote
with a different code in the list using the Direct Code Entry
Method, until you find the code that allows the remote to
control the majority of your component’s functions. Different
codes can provide different levels of functionality.
Problem: The LED does not light when you press a key.
• You may have pressed an invalid key for the mode the remote is
in. You must put the remote in the correct mode by pressing the
corresponding component key (TV, SAT·CBL, DVD•VCR) so the
Limited Lifetime Warranty
Audiovox Electronics Corporation (the “Company”) warrants to you the
original retail purchaser of this product that should it, under normal use
and conditions, be proven defective in material or workmanship during its
User Manual For Rca Universal Remote Rcr3273r Manual
lifetime while you own it, such defect(s) will be repaired or replaced (at the
Company’s option) without charge for parts and repair labor. To obtain repair
or replacement within the terms of this Warranty, the product is to be delivered
with proof of warranty coverage (e.g. dated bill of sale), specification of
defect(s), transportation prepaid, to the Company at the address shown below.
This Warranty does not cover product purchased, serviced or used outside the
United States or Canada. This Warranty is not transferable and does not extend
to costs incurred for installation, removal or reinstallation of the product.
This Warranty does not apply if in the Company’s opinion, the product has
been damaged through alteration, improper installation, mishandling, misuse,
neglect, accident, or the simultaneous use of different battery types (e.g.
THE EXTENT OF THE COMPANY’S LIABILITY UNDER THIS
PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY’S
LIABILITY EXCEED THE PURCHASE PRICE PAID BY PURCHASER
This Warranty is in lieu of all other express warranties or liabilities. ANY
IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY
PURPOSE SHALL BE LIMITED TO DURATION OF THIS WARRANTY.
CONSEQUENTIAL OR INCIDENTAL DAMAGES WHATSOEVER. No
person or representative is authorized to assume for the Company any liability
other than expressed herein in connection with the sale of this product.
Some states/provinces do not allow limitations on how long an implied
warranty lasts or the exclusion or limitation of incidental or consequential
damage so the above limitations or exclusions may not apply to you. This
Warranty gives you specific legal rights and you may also have other rights,
U.S.A.:Audiovox Electronics Corporation, 150 Marcus Blvd., Hauppauge,
CANADA: Audiovox Return Center, c/o Genco, 6685 Kennedy Road,
• Make sure the batteries are fresh and are properly installed.
(See Battery Installation on page 1.) Replace the batteries with
two new AAA batteries, if necessary. Reprogramming may be
Problem: The VCR won’t record.
• Make sure the tape is properly loaded in the VCR.
• Make sure the tape is not write-protected. If the safety tab is
removed the tape is write-protected, and you cannot record onto
Problem: The remote will not change channels on
• You must put the remote in the correct mode by pressing the
corresponding component key (TV, SAT·CBL, DVD•VCR) so the
• Press the ENTER key after you enter a channel number.
• Remove any obstacles between the remote and the component.
Make sure to aim the remote at the IR sensor on the component.
the TV screen.
• Make sure you have connected your component to your TV
properly and selected the correct input. (See your components’
Owner’s Manuals for proper connection procedures.)
• You must put the remote in the correct mode by pressing the
corresponding component key (TV, SAT·CBL, DVD•VCR) so the
• Menu access isn’t supported for all brands. If that’s the case,
you’ll need to use your original remote control to access menu
For more information, please visit www.rca.com
RCR3273 US 03
©2007 Audiovox Corporation
111 Congressional Blvd., Suite 350
Carmel, IN 46032
3 device universal remote
KEY FEATURES
Expanded DVR capability
Controls TV; satellite or cable or digital converter box; DVD or VCR
Ergonomic, thin design
Auto code search
Manual code searches and direct code entry
PRODUCT OVERVIEW
View and Download D-Link N150 user manual online. Powerline AV Wireless Mini Router. N150 Wireless Router pdf manual download. View and Download D-Link DIR-600 - Wireless N 150 Home Router user manual online. 150Mbps Wireless Router. DIR-600 - Wireless N 150 Home Router Wireless Router pdf. D-link wireless n150 home router user manual. D-Link DIR-600 User Manual 1 Section - roduct verview Product Overview Note: Using a power supply with a diferent voltage rating than the one included with the DIR-600 will cause damage and void the warranty for this product. Package Contents DIR-600 Wireless N 150 Home Router Power Adapter.
This 3 device universal remote can control up to three components and works with over 350 brands. It comes with a broad DVD and DVR functionality for satellite or cable or digital converter box, including skip back, skip forward and slow play keys. It comes in black with a contemporary thin design.
Features
- Menu support
- Guide support
- Volume and transport key punch through
- Requires 2 AAA batteries (sold separately)
- Limited lifetime warranty
Rca Universal Remote Manual Pdf
SUPPORT / MANUALS
CUSTOMER REVIEWS
Fabulous remote control.
by CJ O'Martin, on 2018-Aug-30
fabulous remote control, easy to use and I can operate 3 devices at the time .. great quality and optimal operation.